Namelist.input

Back to the WRF-SFIRE user guide.

Variable name	Default Value	Description
&domains		Domain control
sr_x	10	Fire mesh is 10 times finer than the innermost atmospheric mesh in the x direction. This number must be even.
sr_y	10	Fire mesh is 10 times finer than the innermost atmospheric mesh in the y direction. This number must be even.
&fire		Fire control
ifire	0	The fire model does not run
	2	The fire model runs
fire_fuel_read	-1	-1 real fuel data from WPS
		0: set to fire_fuel_cat everywhere
		1: vegetation by altitude for testing
		2: read from file (ideal run only)
fire_num_ignitions	3	Number of ignition lines, max. 5 allowed
fire_ignition_ros1	0.01	Rate of spread during ignition until the specified radius is reached
fire_ignition_start_x1	1000.	x coordinate of the start point of the ignition line 1. All ignition coordinates are given in m from the lower left corner of the innermost domain
fire_ignition_start_y1	500.	x coordinate of the start point of the ignition line 1.
fire_ignition_end_x1	1000.	y coordinate of the end point of the ignition line 1. Point ignition (spreading to a small circle) is obtained by specifying the end point the same as the start point.
fire_ignition_end_y1	1900.	y coordinate of the end point of the ignition line 1
fire_ignition_radius1	18.	Everything within this radius from the ignition location will be ignited.
fire_ignition_start_time1	2.	Time of ignition in s since the start of the run, at the start point of the ignition line.
fire_ignition_end_time1	502.	Time of ignition at the end point of the ignition line. The time is linearly interpolated in between.
fire_ignition_ros2		Up to 5 ignition lines may be given. Ignition parameters with the number higher than fire_num_ignitions are not allowed.
…
fire_ignition_end_time5
fire_wind_height	6.096	The height the fire spread formula takes the wind from (m)
fmoist_run	.true.	run the moisture model to update the fuel moisture classes
fmoist_interp	.true.	interpolate the moisture classes to fuel on the fire mesh
fmoist_freq	0	0=use fmoist_dt as moisture model timestep, 1=run moisture each fire model timestep, 2=each other fire model timestep, etc.
fmoist_dt	600	timestep of the moisture model in seconds, if fmoist_freq=0
initialize_fmc	.true.	initialize fuel moisture classes by fuelmc_g given in namelist.fire
fire_print_msg	1	0: no messages from the fire scheme
		1: progress messages from the fire scheme
fire_print_file	0	0: no files written (leave as is)
		>0: write fire model debug files

There are several more variables in the namelist for setting up various experiments, and then variables for developers’ use only to further develop and tune the numerical methods. Leave the variables for the developers as they are, unless directed by the developers.