How to diagnose fuel properties in WRF-SFIRE

From openwfm
Revision as of 17:10, 2 September 2012 by Jmandel (talk | contribs) (→‎Works with)
Jump to navigation Jump to search
Back to the WRF-SFIRE user guide.

The fuel properties in WRF-Fire are given in file namelist.fire. These serve to create coefficients in the Rothermel's formula. To aid diagnostics it is useful to graph the resulting fire spread rate as a function of wind and slope. The graphs are available in metric units, as well as in English units for direct comparison with the published spread rate graphs for the Scott-Burgan fuel categories.

Prerequisites

Location of the codes

Heat flux diagnostics

  • plot_fuel also computes and prints several diagnostic quantities derived from fuel properties, including total heat density generated by the combustion of the fuel over time (J/m2), and the maximal heat flux density (W/m2) from the initial slope of the fuel loss curve. These can be compared with the statistic printed by WRF-Fire while running (maximal heat flux density, total heat flux of the fire, total heat generated by the fire).

Step-by-step instructions

  • Run WRF-Fire, you can kill it right after the the first time step. There will be file fuels.m created in the current directory.
  • Start Matlab in the directory test/em_fire to set up the search path properly.
  • In Matlab, navigate to the directory with the fuels.m file
  • Type fuels. This will create variable fuel. Say you want to check fuel 3. Type fuel(3) to see what is there.
  • Type plot_fuel(fuel(3)) to create the graph below in metric units, and plot_fuel(fuel(3),'sb') for the same units as in Scott and Burgan (2005). Type help plot_fuel for further information. Note: The graph data were created in WRF-Fire and stored in the fuel variable.
  • Type edit fire_ros to see the fire spread rate calculation recreated in Matlab.
  • Type big(check_ros(fuel)) to make sure the calculation in Matlab is the same as in WRF-Fire, it should return rounding error only (less than 1e-4)

Grass-metric.pngGrass-english.png

Works with

References

  • Anderson, H. E., 1982. Aids to determining fuel models for estimating fire behavior. U.S. Forest Service General Technical Report INT-122. Ogden, UT. pdf (The original 13 fuel models)
  • Baughman, R. G. and F. A. Albini.,1980. Estimating midflame windspeeds. In Sixth Conference on Fire and Forest Meteorology, Seattle, WA (Society of American Foresters) pdf (Windspeed reduction from 20ft)
  • Rothermel, R.C., 1972. A mathematical model for predicting fire spread in wildland fuels. Res. Pap. INT-115. Ogden, UT: U.S. Department of Agriculture, Forest Service, Intermountain Forest and Range Experiment Station. 40 pp. pdf (The original for reference)
  • Rothermel, R. C., 1983. How to predict the spread and intensity of forest and range fires. U.S. Forest Service General Technical Report INT-143. Ogden, UT. pdf (Updated version)
  • Scott, J. H. and Burgan, R. E., 2005. Standard fire behavior fuel models: a comprehensive set for use with Rothermel's surface fire spread model. Gen. Tech. Rep. RMRS-GTR-153. Fort Collins, CO: U.S. Department of Agriculture, Forest Service, Rocky Mountain Research Station, 72 pp. pdf (More detailed fuel models, with rate of spread curves)

External links